Amada HFA700CII Horizontal Fully Automatic Metal Cutting Band Saw

Manufacturer
AMADA

Model
HFA-700CII

Year
2000

Stock #
90-3177

Condition
Used

Specifications

Manufacturer Amada Co., LTD
Model HFA-700CII Horizontal Fully Automatic Metal Cutting Band Saw
Serial No. 70940033
Manufacture Date 20?? - Unfortunately we can not read the last two numbers
Saw Blade 27’3”L x 0.063”T x 2-5/8”W
Blade Speed 50 - 394ft./min, Inverter
Work Load Cap 17640
Cutting Capacity Round: 11.4” - 28” Rectangle: 32”W x 28H”
Saw Blade Motor 15HP
Cutting Fluid Cap 26.4 Gallons - Electric Pump
Chip Disposal Conveyor
Blade Control Top Limit Setting — Auto Setting with Quick Approach Feeler
Electrical Specs 220Volts, 3-Phase, 50/60HZ // All other Voltages Require a Transformer
Index Mechanism Shuttle Type - Stroke: 19.6” Length: 0.39” - 999.999” Remnant Length: 1.38”
Table Height 27.6” Above Floor
Machine Dimensions 157.4”W x 84”L x 112.9”H Approx.
Weight Approx. 15435lbs
Seller Note: Units is USED. Some minor scratching/blemishes/oil film along with signs of other wear on paint can be seen on the surfaces of the unit, but is not affecting the unit intended use. The unit was removed a working environment as seen in the pictures and was functioning as intended when removed from service. This unit was recently removed from production. Unit has been removed from the facility seen in the pictures and is being stored in our facility. Unit is being sold ***AS-IS, WHERE-IS, AS-SHOWN.*** *** PLEASE DO NOT ASSUME THERE IS MORE TO IT. IF YOU ARE UNCERTAIN PLEASE BE SURE TO ASK PRIOR TO PURCHASING***. Pictures are of the actual unit being purchased. If the buyer has any questions, please feel free to ask. As always, buyer is welcome to personally inspect and test unit at our facilities.
EXTRAS: Both Roller Conveyors seen in photo either side of the unit are included in the sale of the saw

Equipped With

High Accuracy for large sized materials

  • This compact machine supports up to 32" x 28”
  • High accuracy cutting, and durability 

 

Band Deviation Monitor

The NC controller constantly monitors the cutting and blade conditions, including the twist of the saw blade. When these exceed the preset parameters in the automatic blade run-out detector the machine will cease cutting and indicate the reason for stopping.

Videos